The LeakVIEW provides an effective visual method of leak detection through either bubble emission, burst test or altitude simulation.
When carrying out bubble emissions testing, the chamber is filled with water prior to testing. During the test phase, the head-space will be placed under the vacuum, causing the package to inflate. Water is not required for altitude simulation or the burst test method. Should any leaks be present within the packaging, a stream of bubbles will be emitted, allowing the user to easily pinpoint the exact location of the leak. The Leakview is able to identify holes smaller than 20 microns. This performance is determined by pack size, vacuum level and head space.
Operated by a simple Selector lever that rotates to hold the vacuum at a chosen level, and then further rotates to control the vent rate. User-friendly and low maintenance, the LeakVIEW vacuum leak tester is an essential piece of equipment for any package testing facility.
- Ideal for bubble emission, burst test or altitude simulation
- Low maintenance with no specialist tooling, electrical connection or calibration required
- User-friendly – one touch, manual control
- Detects holes smaller than 20 microns
- Clear perspex housing allows for optimum viewing
- Custom configurations are available
|Limit of detection
||Better than 20 microns hole diameter|
(Performance is a function of vacuum level and head space)
||0 to -800 mbar <30 seconds at 6 bar line pressure (empty)|
0 to -200 mbar <5 seconds at 6 bar line pressure (empty)
|Internal usable size
||(H) 175mm x (W) 440mm x (D) 310mm (approximately 25 litres)|
||Combination Evacuation, Hold and Vent control|
||0-11 bar pressure, 0-1 bar vacuum|
||6.5 bar (200l/min), 8mm push-fit connection|
||(H) 430mm x (W) 523mm x (D) 510mm (vertical clearance: 750mm)|
||Acrylic test chamber, Grade 304 stainless steel base|
||Is able to operate in compliance with ASTM D3078|
||Directive 97/23/EC Cat S.E.P, Applies|
||Calibration is not required. Gauges may be verified for accuracy|