Rubber Bale Cutter
For sample preparation of sections rubber / polymer bales in a laboratory environment
The bale is placed on this roll conveyor and the desired section size is pushed in the bale cutters. After that you only have to push two safety buttons to activate the cutting process.
For safe operation the lab ball splitter is equipped with a two-hand safety control features. In addition, the cutting room is covered in transparent safety glass.
The CP 3000 is fully pneumatic and does not require an electrical connection. The entire structure of the unit complies with all applicable standards and guidelines
|Number of strokes
||Up to 12 cuts / minute, cutting and lifting speed adjustable|
|Bale width / cutting width
||Max. 520 mm|
|Bale height / cutting height
||Max. 240 mm|
||Adjustable via the included manometer unit.|
Min 0.6 tonnes (at 2.0 bar input pressure)
Max 4.6 tonnes (at 10.0 bar input pressure)
||Hardened and precision ground|
||by roll conveyor, total length 750 mm|
||Pneumatic two-hand safety operation, transparent safety glass as side, front and rear protection|
||Compressed air - no electrical connection required|
||280 kg gross|
255 kg net
The device is designed as a desktop unit to be set it up on a table with appropriate capacity.