Cutting device for planeparallel cutting of samples
Products / Accessories / Software
The new dimension in hardness testing
Hardtest - the test- and evaluation software program Applicable for all electronic Bareiss testing devices with a serial interface. The programme contains all functions which are necessary for a faultless process:
Reading of actual measured values + all measured values of a series of measurements Single values can be erased. Measured values, which are out of the tolerance limits, are marked (<, >). All important statistical values are shown at one glance. In addition the increase and the section of the axes of a regression line of a series of measurements can be determined.
Graphical display of the series of measurements in a diagram and histogram For better view a user-defined range of the diagram can be zoomed. Within the diagram the most important statistical values can be plotted (e.g. tolerance limits, average-, median values, regression line, etc.).
The test protocol can be defined freely (printing of etiquettes, too) The test presetting per series of measurements can be administrated in a data file of articles. For each article a sketch or digital photo can be integrated.
Additional functions: Memorizing of series of measurements on the hard board / other media Series of measurement can be interrupted and preceded at a later date Subsequent processing of series of measurements in other programmes (spreadsheet analysis, data bank ...) is possible.
재료물성시험기 전문 대표자
: 현교승, 사업자등록번호 : 129-81-77003